[1] 马家家.不同壁厚塑件注塑充填不平衡现象的可视化研究[D]. 大连理工大学, 2009.
[2] Martin F A, CANTON N.Combined injection and compression molding: US, 2938232[P].
[3]Guan W S, Huang H X.Back melt flow in injection–compression molding: Effect on part thickness distribution[J].International Communications in Heat & Mass Transfer, 2012, 39(6):792-797
[4]葛勇, 王韬, 郎建林, 等.注射压缩成型工艺参数对厚壁聚碳酸酯制件厚度的影响[J].高分子材料科学与工程, 2015, 31(4):117-120
[5]Allan P S, Bevis M J.Development and application of multiple live-feed moulding for the management of fibres in moulded parts[J].Composites Manufacturing, 1990, 1(2):79-84
[6] 官青, 申开智, 吉继亮.动态保压注射成型技术研究[J].成都科技大学学报, 1995, 5(5):20-26
[7] 晓光.剪切控制定向注射成形 [J].模具技术, 1995, 3(3):63-68
[8] 张治华.控制注射模塑剪应变定向技术 [J].塑料加工与应用, 1993, 2(2):35-41
[9]Rui A S, Rui L R, Cunha A M, et al.Processing and properties of bone-analogue biodegradable and bioinert polymeric composites[J].Composites Science & Technology, 2003, 63(3–4):389-402
[10]V??t?inen O, J?rvel? P, Valta K, et al.The effect of processing parameters on the quality of injection moulded parts by using the Taguchi parameter design method[J].Plastics rubber and composites processing and applications, 1994, 21(4):211-217
[11]Chang T C, Faison III E.Shrinkage behavior and optimization of injection molded parts studied by the Taguchi method[J].Polymer Engineering & Science, 2001, 41(5):703-710
[12] Hopmann C, Neuss A, Weber M, et al.Multilayer injection moulding of thick-walled optical plastics parts[C]// International Conference of the Polymer-processing-society. American Institute of Physics, 2014:146-149. |