基于ANSYS的硬塑气囊盖板弱化研究

doi:10.19491/j.issn.1001-9278.2017.02.013

中国塑料 ›› 2017, Vol. 31 ›› Issue (2): 77-81 .DOI: 10.19491/j.issn.1001-9278.2017.02.013

基于ANSYS的硬塑气囊盖板弱化研究

林健¹,李劲松²,吴章锋²,梅烨²

1. 海南大学机电工程学院2. 海南大学

收稿日期:2016-09-12 修回日期:2016-10-27 出版日期:2017-02-26 发布日期:2017-02-26

Study on Weakening of Hard Plastic Airbag Cover Plates by Ansys Software

Received:2016-09-12 Revised:2016-10-27 Online:2017-02-26 Published:2017-02-26

摘要/Abstract

摘要： 利用ANSYS软件分别对隐式安全气囊中的硬塑气囊盖板进行了弱化结构受力分析和结构优化，通过仿真0.1、0.3、0.5、0.7、1.0、1.5 mm 6种不同残余厚度的气囊盖板在爆破时破裂的难易程度，得出硬塑气囊盖板的最佳弱化深度约为0.5 mm，并进行了气囊爆破试验验证。

关键词: 安全气囊, ANSYS 分析, 硬塑气囊盖板, 弱化

Abstract: This article reported the stress analysis of weakened structure and structural optimization for hard plastic airbag cover plates in an implicit airbag by an ANSYS software. Through simulating the degree of blowingup for the hard plastic airbag cover plate at six different residual thicknesses of 0.1, 0.3, 0.5, 0.7, 1.0 and 1.5 mm, an optimal residual thickness could be determined as around 0.5 mm. This result was also verified by a balloon blasting experiment.

Key words: safety airbag, ANSYS analysis, hard plastic airbag cover, weaken structure

林健, 李劲松, 吴章锋, 梅烨. 基于ANSYS的硬塑气囊盖板弱化研究[J]. 中国塑料, 2017, 31(2): 77-81 .

基于ANSYS的硬塑气囊盖板弱化研究

Study on Weakening of Hard Plastic Airbag Cover Plates by Ansys Software

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 1

编辑推荐

Metrics

本文评价