中国塑料

中国塑料 ›› 2008, Vol. 22 ›› Issue (12): 88-91 .DOI: 10.19491/j.issn.1001-9278.2008.12.020

• 塑料与环境 • 上一篇    下一篇

废旧轮胎胶粉/PP复合材料的研究

张 宁;戴伟民;许昆鹏;刘 敏   

  1. 江苏常州轻工学院轻化工工程系，江苏 常州 213164
  • 收稿日期:2008-09-29 修回日期:1900-01-01 出版日期:2008-12-26 发布日期:2008-12-26

Study on Waste Tire Power Modified Polypropylene Blend

ZHANG Ning;DAI Wei-min ; XU Kun-peng;LIU Min   

  1. Department of light chemical engineering, Institute of light industry technology, Changzhou 213164, China
  • Received:2008-09-29 Revised:1900-01-01 Online:2008-12-26 Published:2008-12-26
  • Contact: ZHANG Ning

摘要： 研究了不同含量的废旧轮胎胶粉对聚丙烯力学性能的影响，并采用脱硫、自由基聚合反应改善两相的相容性。结果表明：加入未经处理的胶粉时，复合材料拉伸强度和断裂伸长率随着胶粉含量的增加而降低。当胶粉含量为70 ％(质量分数，下同)时，拉伸强度由37 MPa降至7 MPa，断裂伸长率由108 ％降至35 ％左右。冲击强度随着胶粉含量的增加呈现先升后降趋势，当胶粉含量为20 ％时，冲击强度达到14 kJ/m2。加入处理后的胶粉，拉伸强度随胶粉含量的增加而降低的趋势变缓。冲击强度和断裂伸长率随着胶粉含量的增加呈现先升后降趋势。胶粉含量为30 ％时，冲击强度可达18.5 kJ/m2，断裂伸长率约为320 ％.

关键词: 废旧轮胎胶粉, 聚丙烯, 复合材料

Abstract: The mechanical properties of polypropylene/waste tire power composites were studied. The compatibility between the components was improved by shucking off sulfur and free radical reaction. It was found that the tensile strength and elongation at break were decreased with increasing tire power. When the tire content was 70 wt%, the tensile strength decreased from 37 MPa to 7 MPa, the elongation at break from 108 % to 35 %. Impact strength increased first and then decreased as content of tire power increased. When the content was 20 %, impact strength was 14 kJ/m2. When modified tire power was employed, these mechanical properties were improved. When the tire powder content was 30 wt%, the impact strength and elongation at break were 18.5 kJ/m2 and 320 %, respectively.

Key words: reused tire power, polypropylene, composite

中图分类号: 

京公网安备11010802034965号　 京ICP备13020181号-2
《中国塑料》编辑部 ©2008-2023 版权所有
地址:北京市海淀区阜成路11号　邮编：100048
编辑部：010-68985541　联系信箱：cp@plaschina.com.cn
广告部/发行部：010-68985253　本系统由北京玛格泰克科技发展有限公司设计开发